Коды ошибок

  1. 4853 Robot/Loader power sequence error
  2. 4900 Motor not ready to start
  3. 4903 Power on effective parameter set
  4. 4904 Barrier invasion
  5. 0100 Device name
  6. 0101 Sector device name
  7. 0102 Print device name
  8. 0105 File name
  9. 0106 Command character
  10. 0107 Command syntax
  11. 0108 Option
  12. 0110 File attribute
  13. 0111 Device full
  14. 0112 Disk uninitiolized
  15. 0114 Error-map information
  16. 0118 SVCL
  17. 0124 Memory disk access sector over
  18. 0126 DMA transfer sector over
  19. 0127 Memory disk battery voltage low
  20. 0128 Memory disk format
  21. 0130 Floppy disk read/write
  22. 0131 Floppy disk access sector over
  23. 0132 Floppy disk write verify
  24. 0133 Floppy disk seek
  25. 0134 Floppy disk recalibrate
  26. 0135 Floppy disk formatting
  27. 0136 Floppy disk time out
  28. 0137 Floppy ready
  29. 0138 Floppy disk write protect
  30. 0143 DMA transfer
  31. 0146 CAP/ACP ready
  32. 0147 Memory write/read test
  33. 0148 Program load
  34. 0149 Not fond program file
  35. 0150 Program load address
  36. 0151 Program attribute
  37. 0152 Memory disk ROM write
  38. 0153 ROM card write prohibit
  39. 0154 floppy RS232C block
  40. 0155 sector device initialized
  41. 0200 System file data
  42. 0201 MAB full
  43. 0202 Record buffer over flow
  44. 0203 Load object address
  45. 0204 Load object attribute
  46. 0205 Load verify
  47. 0206 Data block size
  48. 0205 Selected number
  49. 0252 memory disk RAM format
  50. 0254 Memory disk RAM write/read test
  51. 0255 FR-part-file size
  52. 0256 FR-part-file number
  53. 0257 FR-part-file load address
  54. 0258 Size over
  55. 0261 Data write verify
  56. 0262 Memory disk ROM erase
  57. 0263 File header
  58. 0264 Install mode program load
  59. 0265 Control-software attribute
  60. 0267 Work area size
  61. 0268 Memory disk battery voltage low
  62. 0300 Device name
  63. 0301 Sector device name
  64. 0302 Print device name
  65. 0303 Reader device name

 

<< Назад 1 2 3 4 5

 
 

Программирование станков с ЧПУ Okuma OSP-U100L, OSP-U10L. Правила, функции, коды, команды, примеры программ.
При копировании материалов ссылка на сайт обязательна.